Prices for services are based on reasonably straightforward service times, service prices are subject to change due to unknown/unexpected issues that we may encounter during the service.
A/C Service (Chassis) / Recommended Annually
For chassis dash units that are operating correctly and blowing cold, clean condensor fins, check condensor and blower fans, check system presssures, inspect A/C belt and overall condition of the system.
Inspect the cover for cracks, integrity and security, remove cover clean the condensor and evaperator with coil cleaner, clean condensate pan, and any forien material in the unit. Straighten bent fins if necessary, reinstall the cover. Clean or replace the air filter, check for proper operation and cooling differential of the unit.
Inspection Service (Electrical) / Recommended Annually
Inspect the integrity of the 12 and 110-volt systems on the rig. Test Converter/inverter function, Inspect fuse blocks and breaker box for overheating conditions. Check for proper polarity on the 110-volt system plugs, inspect shore cord and generator for proper working condition and operation.
Oil Change Service (LOF Engine) / Recommended 3,000/miles
Eng – $240 + materials
Inspect the underside of the engine look for any leaks or problems, change the oil and filter, and lubricate the chassis grease points. Engine oil is a synthetic 5W-20 or 5W-30 blend depending on engine type unless otherwise requested by the customer. Fuel filter change will be an additional $80.00 + the fuel filter.
Oil Change Service (LOF Generator) / Recommended 100/Hours
Gen – $240 + materials
Inspect the underside of the engine look for any leaks or problems, change the oil and filter. Engine oil is Rotella 15w-40 unless otherwise requested by the customer. Fuel filter change will be an additional $80.00 + the fuel filter.
Inspect the unit for rust, corrosion, and water damage, check condition of burner assy and LP operation. Clean out any critter nests and ensure flue is clear. Inspect door seals and operation on all power modes.
For slides that are currently operational, lubricate gear mechanisms and tracks, treat the rubber bulb and wiper seals with lubricant, inspect for wear and leak points, check for proper alignment and operation.
Transmission Flush Service / Recommended 3-5 years or 30,000 miles
$450 Gas Unit
Remove pan, if needed, drain oil & change filter, clean pan and magnet, install new gasket and reinstall pan, fill with synthetic transmission fluid to proper level and cycle the gears to ensure no air is trapped.
Wheel Bearing Service (Steering Axle) / Recommended Annually
$250 per axle
Helps prevent bearing failure and wheel play/steering issues. Remove hub, clean and inspect brakes and bearings, pack with JT-7 grease and reassemble. Set preload and test wheel and brakes for proper operation.
Winterize/De-Winterize / Recommended Prior to Freezing
Winterize – drain water heater and fresh water tank, close water heater bypass valves, blow out all lines with compressed air, fill P-traps with antifreeze, and pump up to 2 gallons of antifreeze into system.
De-winterize – Un-bypass the water heater, hook up city water and flush antifreeze out of system, check water heater function and check for any leaks.