For chassis dash units that are not blowing cold or otherwise not cooling, evacuate, leak check, and recharge the system.

Inspect the integrity of the awning arms, tube, and springs, remove old fabric and replace with new fabric.

Top off water, clean battery and terminals, check CCA and voltage, perform a draw test, apply corrosion protectant.

Replace old fluid with fresh fluid, bleed the brakes in the process and ensure there is no air in the system.

Remove coolant, add water and flush chemical, run to operating temperature, drain, rinse, and fill with fresh anti-freeze.  Include up to 4 gallons of anti-freeze.

Remove coolant, add water and flush chemical, run to operating temperature, drain, rinse, and fill with fresh anti-freeze.  Include up to 4 gallons of anti-freeze.

Inspect the integrity of the unit, look for corrosion on components and rust.  Look for any upcoming problems, check for proper operation and function, clean out any critter nests.

Inspect all appliances and accessories for proper operation includes awnings, toppers, appliances, TV’s, antennas, stove/oven, refrigerator, water heater and pump, and furnace.

Inspect the integrity of the 12 and 110-volt systems on the rig.  Test Converter/inverter function, Inspect fuse blocks and breaker box for overheating conditions.  Check for proper polarity on the 110-volt system plugs, inspect shore cord and generator for proper working condition and operation.

Inspect all critical components of the unit from chassis to house.  Check all appliances, perform LP Drop test, inspect chassis for condition and problems, inspect belts and brakes, check generator, plumbing and electrical systems for proper operation.

We can do you Texas State inspections here.  We know what is required and have the facilities and equipment to get it done.

Inspection fees are set by the state of Texas, no appointment is needed for an inspection, please have your insurance card available, we will need that.

Inspect the underside of the engine look for any leaks or problems, change the oil and filter, and lubricate the chassis grease points.  Engine oil is Rotella 15w-40 unless otherwise requested by the customer.

Inspect the system for condition and evidence of chafing lines, inspect regulator, perform an LP Drop test which tests the system integrity.  Check LP detectors.

Inspect the unit for rust, corrosion, and water damage, check condition of burner assy and LP operation.  Clean out any critter nests and ensure flue is clear.  Inspect door seals and operation on all power modes.

Clean the roof with specialty cleaning agents and apply specialty UV blocking agents to the roof to protect it.

For slides that are currently operational, lubricate gear mechanisms and tracks, treat the rubber bulb and wiper seals with lubricant, inspect for wear and leak points, check for proper alignment and operation.

Install Sumo Springs on the front or rear axle, helps with sway and control of the vehicle when in wind and around large trucks.

Install auxilliary sway bars on the front or rear axle, helps with sway and control of the vehicle when in wind and around large trucks.

Checks the condition of the anode rod, pressure relief valve, check condition of board, burner, clean out critter nests, check for proper operation.

Helps prevent bearing failure and wheel play/steering issues.  Remove hub, clean and inspect brakes and bearings, pack with JT-7 grease and reassemble.  Set preload and test wheel and brakes for proper operation.

Winterize – drain water heater and fresh water tank, close water heater bypass valves, blow out all lines with compressed air, fill P-traps with antifreeze, and pump up to 2 gallons of antifreeze into system.

De-winterize – Un-bypass the water heater, hook up city water and flush antifreeze out of system, check water heater function and check for any leaks