Prices for services are based on reasonably straightforward service times, service prices are subject to change due to unknown/unexpected issues that we may encounter during the service.
A/C Service (Chassis) / Recommended Annually
$200
For chassis dash units that are operating correctly and blowing cold, clean condensor fins, check condensor and blower fans, check system presssures, inspect A/C belt and overall condition of the system.
Inspect the cover for cracks, integrity and security, remove cover clean the condensor and evaperator with coil cleaner, clean condensate pan, and any forien material in the unit. Straighten bent fins if necessary, reinstall the cover. Clean or replace the air filter, check for proper operation and cooling differential of the unit.
Coolant Flush Service / Recommended 3-5 years or 30,000 miles
$600 Diesel Unitw/up to 4 gallons of Anti Freeze
Drain coolant, add flush chemical and water, run unit to operating temperature, drain, rinse, and fill with fresh anti-freeze, flush includes up to 4 gallons of antifreeze.
Drain coolant, add flush chemical and water, run unit to operating temperature, drain, rinse, and fill with fresh anti-freeze, flush includes up to 4 gallons of antifreeze.
Inspection Service (Appliance/Accessories) / Recommended Annually
$150
Inspect all appliances and accessories for proper operation includes awnings, toppers, appliances, TV’s, antennas, stove/oven, refrigerator, water heater and pump, and furnace.
Inspection Service (Electrical) / Recommended Annually
$150
Inspect the integrity of the 12 and 110-volt systems on the rig. Test Converter/inverter function, Inspect fuse blocks and breaker box for overheating conditions. Check for proper polarity on the 110-volt system plugs, inspect shore cord and generator for proper working condition and operation.
We are an authorized Texas State inspections station. We know what is required and have the facilities and equipment to get it done.
Inspection fees are set by the state of Texas, no appointment is needed for an inspection, please have your insurance card available, we will need that.
Oil Change Service (LOF Engine) / Recommended 5,000/miles
Eng – $240.00 + materials
Inspect the underside of the engine look for any leaks or problems, change the oil and filter, and lubricate the chassis grease points. Engine oil is Rotella 15w-40 unless otherwise requested by the customer. Fuel filter change will be an additional $80.00 + the fuel filter.
Oil Change Service (LOF Generator) / Recommended 150 Hours
Gen – $240.00 + materials
Inspect the underside of the engine look for any leaks or problems, change the oil and filter, and lubricate the chassis grease points. Engine oil is Rotella 15w-40 unless otherwise requested by the customer. Fuel filter change will be an additional $80.00 + the fuel filter.
Inspect the system for condition and evidence of chafing lines, inspect regulator, perform an LP Drop test which tests the system integrity. Check LP detectors.
Inspect the unit for rust, corrosion, and water damage, check condition of burner assy and LP operation. Clean out any critter nests and ensure flue is clear. Inspect door seals and operation on all power modes.
For slides that are currently operational, lubricate gear mechanisms and tracks, treat the rubber bulb and wiper seals with lubricant, inspect for wear and leak points, check for proper alignment and operation.
Sumo Spring Service / Recommended for Better RV Ride
$225 Front + Springs
$299 Rear + Springs
Install Sumo Springs on the front or rear axle, helps with sway, control and ride of the vehicle when in wind and around large trucks and just going down the road.
Sway Bar Install Service / Recommended for Better RV Ride & Control
$225 Front + Bars
$299 Rear + Bars
Install auxilliary sway bars on the front or rear axle, helps with sway, control and ride of the vehicle when in wind and around large trucks and just going down the road.
Transmission Flush Service / Recommended 3-5 years or 30,000 miles
$550 Diesel Unit
Remove pan, if needed, drain oil & change filter, clean pan and magnet, install new gasket and reinstall pan, fill with synthetic transmission fluid to proper level and cycle the gears to ensure no air is trapped.
Check the condition of the anode rod, pressure relief valve, inspect condition of board, burner, connections, look for corrosion on terminals, clean out critter nests, check for proper operation.
Wheel Bearing Service (Steering Axle) / Recommended Annually
$250 per axle
Helps prevent bearing failure and wheel play/steering issues. Remove hub, clean and inspect brakes and bearings, pack with JT-7 grease and reassemble. Set preload and test wheel and brakes for proper operation.
Winterize/De-Winterize / Recommended Prior to Freezing
$150
Winterize – drain water heater and fresh water tank, close water heater bypass valves, blow out all lines with compressed air, fill P-traps with antifreeze, and pump up to 2 gallons of antifreeze into system.
De-winterize – Un-bypass the water heater, hook up city water and flush antifreeze out of system, check water heater function and check for any leaks.